Yamaha side slot cartridge adapter - any interest?

Guardian (3571)

04-03-2019, 00:19

Is there any interest in the Yamaha side slot cartridge adapter project? The adapter comes with a 3d-printed case and should look like that:

Internally there will be 2 boards and 50 pin ribbon cable between them, nothing else.

Aangemeld of registreer om reacties te plaatsen

Van alexito

Paladin (761)

04-03-2019, 01:00

I'm in just for the PCB and the extension connector I think the case is not necessary for me because I wanna try to connect MSX cartridges like the FS-CA1 or FS-UV1

PS: how long the extension cable can be?

Van max_iwamoto

Hero (628)

04-03-2019, 00:54

I would like at least 2 of them, complete with case.

Van alexito

Paladin (761)

04-03-2019, 01:07

This is just one reason why I want to buy the cartridge adapter.

picture

Van sd_snatcher

Prophet (3645)

04-03-2019, 14:16

How much will it cost?

Van NYYRIKKI

Enlighted (6033)

04-03-2019, 15:00

Yes

Van Wierzbowsky

Guardian (3571)

04-03-2019, 15:36

If I make the batch of 10, then the cost will be around 35-40 Euro for the complete adapter.

Van MSX4ever

Master (251)

04-03-2019, 15:37

I would like one too

Van Grauw

Ascended (10707)

04-03-2019, 15:39

Also interested in one.

Van sdsnatcher73

Prophet (3849)

04-03-2019, 16:13

Me too!

Van Wierzbowsky

Guardian (3571)

05-03-2019, 03:18

Ok, boards' design is ready, the 3D model has been adjusted a bit.

Now printing the case...